Spread the love

There is nothing finer in life than after a hard day’s work sliding into a nice warm bath. Go on you deserve it and the addition of salts and bubbles can only make it better. The bath that you get into is very important. In most cases we have plastic baths or even a ceramic one but have you ever considered a nice Cast Iron Baths Ireland has some of the best to offer and a visit to the website of https://www.wilsonsyard.com will give you some great ideas. Cast iron baths are usually standalone affairs and have that wonderful Victorian effect of cast iron feet. How exactly are they made?

Image Credit

The traditional Victorian method of making a cast iron bath, and one that is still done today in some cases is to the use mined Iron Ore. In our more ecologically minded modern times this is not the case so much as it was as the plundering of the world’s resources are now seen as very limited. Therefore, when you slide into the bath it’s not uncommon for the substance of the iron to be made from a variety of sources. For example, the makeup of the baths metal could be from old car parts, unused manhole covers, redundant radiators and other assorted scrap metal. It’s a lot cheaper to use these bits of recycling than it is to spend the money mining out the ore as this is now restricted to areas that are expensive to export from such as Australia where the largest concentration of iron ore sits.

Image Credit

Once the material is collected at the manufacturer the next stage is to melt the metal in to a molten state. This does require an extremely high heat about one thousand and four hundred Celsius, but once the metal is at the molten stage it is now in the perfect condition to be mould into the shape that is required. The cast iron baths manufacturer has an array of moulds that can give the metal its new and more useful shape. The metal is poured into the mould for the bath design that is required where. The cast mould is made up of a combination moist sand and clay that bound and company the metal into the shape required. Once this is set in place the mould is taken to the cooling section where it is gradually reduced in temperature so as not to crack the bath.

All that is then needed is for a glass powder to be sprayed on to give the bath and undercoat and then an enamel layer added for smoothness and protection. The bath is heated again to red hot and another enamel coating applied. The cast iron bath is superb at retaining heat and keeping it the water warm for longer periods.

Hi, I am Russell ; I am an entrepreneur, father, mentor and adventurer passionate about life. At this moment, I am working with depression and anxiety.

Leave comment

Your email address will not be published. Required fields are marked with *.